Quantum Power Bases
R-TRAK Specifications
| Maximum Speed1 |
Up to 7 mph (11 km/h) Up to 3.5 mph (5.6 km/h) with 10-in. lift |
| Ground Clearance2 | 3.97 in. (101 mm) at battery tray |
| Turning Radius2 | 25.7 in. (653 mm) |
| Overall Size2,6 |
Stowage Length: 34.8 in (884 mm) without front rigging Length: 44.5 in. (1130 mm) with front riggings Width: 24.2 in. (616 mm) |
| Drive Wheels | 14 in. (356 mm), solid or pneumatic |
| Caster Wheels | 9 in. (229 mm), solid |
| Anti-tip Wheels | 4 in. (102 mm), flat free |
| Range1,4 | Up to 16.34 miles (26.3 km) with Group 24 batteries |
| Component Weights5 |
Base: 128 lbs. (58 kg) Batteries: Group 24: 51.5 lbs. (23.36 kg) each (standard) |
| Drivetrain | Two motor, rear-wheel drive |
| Brakes | Electronic regenerative, disc park brake |
| Batteries3 |
Two 12 volt, Flat top deep-cycle Group 24: C20 75 Ah, C5 62 Ah |
| Battery Charger | 8 amp, off-board |
| Freewheel Operational Force | Less than 60 N |
| Drive Control Operational Force | Less than 5 N |
| Maximum Rated Slope | 7.5° (13.2%) |
| Maximum Obstacle Climbing Ability (Ascending and Descending) | 2.36 in. (60 mm) |
| Measured Sound Level (A-weighted) | Less than 65 dB |
Notes: 1 Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery condition, motors, controller type, tire type, and tire condition. This specification is subject to a variance of +10%, -5%. 2 Due to manufacturing tolerances and continued product improvement, this specification can be subject to a variance of (+ or -) 3%. 3 AGM, Gel-Cell, or Hybrid Gel (Hybrid Gel is defined as Nano Silica Gel Electrolyte with High Quality Glass Mat Separators) type required. See “Batteries and Charging.” 4 Tested in accordance with ANSI/RESNA, WC Vol. 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculations based on battery specifications and drive system performance. Test conducted at maximum weight capacity. 5 Battery weight may vary based on manufacturer. 6 Dimensions listed are for power base only. Overall measurements will vary based on seating and accessory selections. |
|
NOTE: This product conforms to all applicable ANSI/RESNA, ISO 7176 Series, AS/NZS 3695.2, and EN12184 standards.
The information contained herein is correct at the time of publication; we reserve the right to alter specifications without prior notice.